SOUND / POWER

PROBLEM

CAUSE

FIX

The SoundStage does not turn ON

The AC power supply cable is not firmly connected to the AC   wall outlet.

Connect the AC power supply cable firmly

to the AC wall outlet.

The SoundStage is not switched to the ‘ON’ position on the Side panel

Press the ON/OFF switch on the side panel of the SoundStage

No sound.

Incorrect input or output cable connections to the back of the SoundStage

Connect the cables properly. If the problem

persists, the cables may be defective.

The sound is set to mute

Press MUTE or VOLUME +/– on the remote control or front panel

The correct input source has not been selected.

Select an appropriate input source with

INPUT button on the front panel or remote control

The sound suddenly goes

Off.

The sound may be set to MUTE

Press MUTE or VOLUME +/– on the remote control or front panel

No sound from the centre

Speaker

The volume level of the centre speaker is set to minimum.

Raise the level of the centre speakers using the button on the remote control.

No sound from the surround speakers

The volume level of the  individual speakers is set to minimum.

Raise the level of the individual speakers using the button on the remote control.

Dolby Digital or DTS sources

cannot be played back.

The connected component is not set to output Dolby Digital or DTS digital signals.

Make an appropriate setting following the operating instructions for your component.

LCD on front panel does not appear.

Connect the Power Cable properly.

Check the unit is switched ON from the side panel switch

REMOTE CONTROL

PROBLEM

CAUSE

FIX

The remote control does not work and/or function

properly.

Remote is being used at the wrong distance or angle.

Reposition the remote control

The remote control has a 7 metre operating range at a 30 degree angle left or right away from the SoundStage

Direct sunlight or lighting (from an inverter type of fluorescent lamp, etc.) is striking the remote control sensor of this unit.

Reposition the SoundStage

The batteries are weak.

Replace all batteries in the remote control

FM TUNER

PROBLEM

CAUSE

FIX

FM stereo reception is noisy.

The characteristics of FM broadcasts may cause this problem

Check the antenna connection or positioning

Use the manual tuning method.

FM Reception is distorted

There is an interference in the reception

Adjust the antenna position

The FM station cannot be tuned using the automatic tuning method.

The signal is too weak.

Use the manual tuning method.

Preset stations can no longer be tuned into.

This unit has been disconnected for a long period.

Preset the stations again.

The FM station has not be saved correctly

Please refer to the frequency save method on page 6

The remote control is not functioning

Replace all batteries in remote control